品牌 : |
春晨 |
型号 : |
YC |
线芯材质 : |
裸铜线 |
芯数 : |
3 |
电线 外径 : |
200 |
护套厚度 : |
1.2 |
标称截面 : |
3*16 |
产品认证 : |
CCC |
物料编号 : |
2 |
长度 : |
100 |
加工定制 : |
是 |
温度范围 : |
70 |
小弯曲半径 : |
10 |
线径密度 : |
11 |
牵引段裂张力 : |
13 |
江苏春晨电缆有限公司生产YC移动橡套软电缆,YC移动橡套软电缆,
经过一个电流互感器测量单相电流的电路
Circuit for Measuring Single Phase Current through a Current Transformer
在交流电路中,如果被测电流较大,或者被测量电路的电压较高,都可以使用电流互感器和量程为5A的交流电流表测量电流,这是为了扩大电流表量程,同时也比较安全。电路的接线如下图所示,左边的是平常我们使用交流电流表的测量电路,直接串联负载进行测量,右边是需要用到电流互感器时的电流测量电路图。
In AC circuit, if the measured current is large or the voltage of the measured circuit is high, the current can be measured by current transformer and an AC ammeter with a measuring range of 5A. This is in order to expand the measuring range of the ammeter and is also relatively safe. The wiring of the circuit is shown in the following figure. On the left side, we usually use the measuring circuit of the AC current meter to measure the load directly in series. On the right side, we use the current measuring circuit when the current transformer is needed.
经过一个电流互感器测量单相电流的电路
Circuit for Measuring Single Phase Current through a Current Transformer
经过一个电流互感器测量单相电流的电路
Circuit for Measuring Single Phase Current through a Current Transformer
使用电流互感器测量时应注意:
When using the current transformer to measure, attention should be paid to:
互感器二次侧不允许开路,因此,二次侧不能安装熔断器和串联开关。
No open circuit is allowed on the secondary side of transformer, so fuses and series switches can not be installed on the secondary side.
为了安全二次绕组的一端必须可靠接地。
In order to be safe, one end of the secondary winding must be grounded reliably.
为您精选
发送询价单
您对该公司的咨询信息已成功提交,请注意接听供应商电话。
联系人信息
请输入您的称呼
请输入正确的联系方式
请选择咨询问题
请输入正确的图形验证码
商家已收到您的消息,请注意接听供应商的来电~
确保商家能在第一时间与您取得联系
请留下您的联系方式
请输入正确的联系电话
请输入称呼或公司名称
请输入验证码